Cf_Keystone Command; Cf_Kystnmode Command; Cf_ Anamorphic Command - Canon LV-7565 Specification

Expand Serial Command Specification

8.7.5. CF_KEYSTONE Command

Command "CF_KEYSTONE_%1" [CR]
"UP" --------- Make the screen image length at the top edge shorter with a
"FUP" ------- Make the screen image length at the top edge shorter with a large
"DN" -------- Make the screen image length at the bottom edge shorter with a
"FDN" ------ Make the screen image length at the bottom edge shorter with a
%1 "LEFT" ----- Make the screen image length at the left edge shorter with a
"FLEFT" --- Make the screen image length at the left edge shorter with a large
"RIGHT" --- Make the screen image length at the right edge shorter with a
"FRGT" ---- Make the screen image length at the right edge shorter with a
"RST" ------- Keystone off
Change Keystone range. (Only valid when it is in the usual Power On state)
Details When the range is over the maximum, a Projector accepts the Command, but it
does not execute.
Acceptable
Response
Unacceptable

8.7.6. CF_KYSTNMODE Command

Command "CF_KYSTNMODE_%1" [CR]
"STR" ---------- Set Keystone store mode to Store
%1
"RST" ---------- Set Keystone store mode to Reset
Details Set Keystone store mode. (Only valid when it is in the usual Power On state)
Acceptable
Response
Unacceptable

8.7.7. CF_ ANAMORPHIC Command

Command "CF_ANAMORPHIC_%1" [CR]
"ON" ---------- Set Anamorphic to On
%1
"OFF" --------- Set Anamorphic to Off
Set Anamorphic On / Off. (Only valid when it is in the usual Power On state)
Details When Anamorphic set to On, the screen will be 4:3 even if it is HDTV.
When Anamorphic set to Off, HDTV will be 16:9.
Acceptable
Response
Unacceptable
small range.
range.
small range.
large range.
small range.
range.
small range.
large range.
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Page 25 of 46