Cf_Tint Command; Cf_Sharp Command - Canon 7215 - LV XGA LCD Projector Specification

EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.4.4 CF_TINTCOMMAND
COMMAND "CF_TINT_%1" [CR]
"000-063"------ Directly select for Tint setting value
%1 "UP"---------------- Current Setting value +1
"DN"---------------- Current Setting value-1
Set the user Control tint value.
The value set by this command will not be save to the projector. Therefore,
Details when ALL OFF the projector, the value will return to the original setting.
(For STANDBYMODE, this value stays.)
NORMAL Power ON state.
Acceptable
Response
Unacceptable
8.4.5 CF_SHARPCOMMAND
COMMAND "CF_SHARP_%1" [CR]
"000-015"------ Directly select for Gamma setting value
"UP"---------------- Current Sharpness setting value＋1
%1
"DN"---------------- Current_Sharpnes ssetting value -1
Set the user Control Sharpness value.
The value set by this Command will not be saved to the projector.
Details Therefore, when ALL OFF the projector, the value will return to the original
setting. (For STANDBYMODE, this value stays.) Only valid when it is
the usual Power ON state.
Acceptable
Response
Unacceptable
8.4.6 CF_GAMMACOMMAND
COMMAND "CF_GAMMA_%1" [CR]
"000-015"------ Directly select for-GAMMA setting value
%1 "UP"-----------------GAMMA setting value＋1
"DN"-----------------GAMMA setting value-1
Set the User Control-GAMMA Value
The value set by this Command will not be saved to the projector.
Details Therefore, when ALL OFF the projector, the value will return to the original
setting. (For STANDBYMODE, this value stays) Only valid when it is in
the usual Power On state.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Only valid when it is in the
Page 16