Image Command; Cf_Bright Command; Cf_Cont Command; Cf_Color Command - Canon LV-5220 - Multimedia Projector SVGA Functional Specification

Expand Serial Command Functional Specification

8.4. Image Command

8.4.1. CF_BRIGHT Command

Command "CF"_BRIGHT_%1" [CR]
"000 – 063" ----------- Directly select the Bright setting value
%1 "UP" -------------------- Bright setting value +1
"DN" -------------------- Bright setting value -1
Set the user control Bright value.
The value set by the command will not be saved to the Projector.
Details Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable

8.4.2. CF_CONT Command

Command "CF_CONT_%1" [CR]
"000 – 063" ------------ Directly select the Contrast setting value
%1 "UP" --------------------- Contrast setting value +1
"DN" --------------------- Contrast setting value -1
Set the user control Contrast value.
The value set by the command will not be saved to the Projector.
Details
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable

8.4.3. CF_COLOR Command

Command "CF_COLOR_%1" [CR]
"000 – 063" ------------ Directly select the Color setting value
%1 "UP" --------------------- Color setting value +1
"DN" --------------------- Color setting value -1
Set the user control Color value.
The value set by the command will not be saved to the Projector.
Details Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable

8.4.4. CF_TINT Command

Command "CF_TINT_%1" [CR]
"000 – 063" ------------ Directly select the Tint setting value
%1 "UP" --------------------- Tint setting value +1
"DN" --------------------- Tint setting value -1
Set the user control Tint value.
The value set by the command will not be saved to the Projector.
Details Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
Page 12 of 41