11
Enjoying through External Equipment
To delete information about all devices:
1
Press
/
to select "Delete All", and then press
ENTER.
2
Press
/
to select "Delete" and then press
ENTER.
• A confirmation message appears.
• A warning message appears if the selected
device has been preset for recording with the
timer or if its power is on. If you delete a device
that has been preset for recording, its all
presettings are deleted.
3
Press
/ to select "OK", and then press ENTER.
76
En
PDP5040HD-Eng (65-80)
76
Setting up for i.LINK standby
Use the following procedure to enable data transfer
between multiple i.LINK devices even when the system
is in the standby mode.
1
Press HOME MENU.
2
Press
/
to select "DTV Setup", and then press
ENTER.
3
Press
/
to select "i.LINK Setup", and then
press ENTER.
4
Press
/
to select "i.LINK Standby", and then
press ENTER.
5
Press
/
to select "Enable", and then press
ENTER.
6
Press HOME MENU to exit the menu.
• With "Enable" selected, the system relays data
between multiple i.LINK devices even when in the
standby mode; the i.LINK circuits are energized in
that mode.
• With "Disable" (factory default) selected, less power
is consumed when the system is in the standby
mode; however the system does not relay data
between multiple i.LINK devices. When i.LINK de-
vices are not in connection, select "Disable", result-
ing in less power consumption.
In standby mode
i.LINK device
Media Receiver
No data relay
7/24/03, 2:00 PM
i.LINK device