Routing Cables - Pioneer PDP-4340HD Operating Instructions Manual

Preparation

Routing cables

Speed clamps and bead bands are included with this system for bunching cables. Once properly bunched, follow
the steps below to route the cables.
When the speakers are installed on the sides
Speaker cable
Attaching speed clamps to the main unit
Attach the speed clamps using the 4 holes marked with
below, depending on your routing system.
When the speakers are installed at the bottom
PDP5040HD-Eng (17-27)
Cable binders (supplied
with the stand)*
Speaker cable
Cable binders (supplied
with the stand)*
21
(rear view)
Speed clamps Speaker cable
Attaching and removing speed clamps
Insert 1 into an appropriate hole on the rear of the
Plasma Display and snap 2 into the back of 1 to lock
the clamp.
Speed clamps are designed to be difficult to undo once
in place. Please attach them carefully.
Use pliers to twist the clamp 90°, pulling outward. The
clamp may deteriorate over time and become damaged
if removed.
2
1
Speaker cable
* Cable binder
Using the cable binders supplied with the stand, put the
speaker and system cables together so that the cables are
invisible from the front. At that time be careful not to apply
any force to the connection sections of the cables.
7/24/03, 1:58 PM
07
21
En