Each Setting And Adjustment; Adjustment Required When The Unit Is Repaired Or Replaced - Pioneer PRO-110FD Service Manual

1

8. EACH SETTING AND ADJUSTMENT

A
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.

8.1 ADJUSTMENT REQUIRED WHEN THE UNIT IS REPAIRED OR REPLACED

B
When any of the following assemblies is replaced
POWER SUPPLY Unit
DIGITAL Assy
C
X DRIVE Assy
Y DRIVE Assy
Service Panel Assy
MAIN Assy (*)
D
PANEL SENSOR Assy
Other assemblies
E
(*) : When replacing the MAIN Assy, be sure to perform the FINAL SETUP.
F
122
1
2
Note: Checking the Cable Card ID
The PDP has a slot for a cable card that is used for managing your
information by the cable TV company. The following procedure
allows you to check your Cable Card ID and the Host ID.
1. Press HOME MENU.
2. Select "Tuner Setup". (
3. Select "Channel Setup". (
4. Select "POD ID". (
• The Host ID and Cable Card ID appear.
5. Press HOME MENU to exit the menu.
PDP-5010FD
2
3
Refer to "8.3 HOW TO CLEAR HISTORY DATA" and
"8.6 PRECAUTION ON REPLACEMENT OF THE
POWER SUPPLY UNIT".
Writing of backup data is required.
Refer to the "8.2 BACKUP OF THE EEPROM
(DIGITAL ASSY)".
No adjustment required
No adjustment required
Refer to "8.3 HOW TO CLEAR HISTORY DATA" and
"8.4 ADJUSTMENTS WHEN THE SERVICE PANEL
ASSY IS REPLACED".
No adjustment required
Writing of backup data is required.
Refer to the "8.2 BACKUP OF THE EEPROM
(DIGITAL ASSY)".
No adjustment required
/ then ENTER)
/ then ENTER)
/ )
3
4
4