Routing Cables; Attaching The Ferrite Core - Pioneer PDP-507XDA Operating Instructions Manual

Preparation
PDP-427XDA (rear view)
Distributor
(commercially
available)
Digital TV
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• For viewing both analogue and digital broadcasts, first connect
the antenna cable to a distributor. Then, connect the two
antenna cables from the distributor to the ANT IN (digital input)
and ANT IN (analogue input) terminals.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma display.
Distributor (commercially available)
Make sure to use a distributor for VHF/UHF.
Note
• If the antenna is not connected correctly, the quality of reception
may be impaired. If images are not displaying correctly, check
whether the antenna connection is correct or not.

Routing cables

Use the speed clamps as necessary to route the connecting
cables. The diagrams below show the location of the holes on the
rear of the display.
PDP-507XDA (rear)
PDP-427XDA (rear)
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma display
and snap [2] into the back of [1] to lock the clamp.
3 4 • Speed clamps are designed to be difficult to undo once in
• Use pliers to twist the clamp 90º, pulling outward. The clamp
Analogue TV
• Be careful not to subject any connecting cables to strain.
Tidying the speaker cables (PDP-507XDA only)
Use the supplied bead bands as necessary to tidy the speaker
cables.

Attaching the ferrite core

To help prevent noise, attach the supplied ferrite core to the
connector end of the power cord as shown. Use the supplied cable
tie to prevent the ferrite core from slipping on the cable.
• Disconnect the power cord from the power outlet when the
2
1
place. Please attach them carefully.
may deteriorate over time and become damaged if removed.
Speaker cables
Bead band
1
2
3
To power outlet
AC power cord
Note
plasma display is not going to be used for a long period of time.
05
4
Ferrite core
Cable tie
As close as possible
17
En