Routing Cables - Pioneer PDP-4350HD Operating Instructions Manual

Preparation
Routing cables
Speed clamps and bead bands are supplied for bunching cables, Once properly bunched, follow the steps below to route the
cables,
When the speakers are installed on the sides
/ i
/ i
/ i
/ i
(rear view)
m
0_
Speaker cable Cable binders (supplied Speed clamps Speaker cable
with the stand)*
Attaching speed clamps to the main unit
Attach the speed clamps using tile 4 holes marked with l
below, depending on your routing system,
Attaching and removing speed clamps
Inset1 [1] into an appropriate bole on tile rear of the Plasrna
Display and snap [2] into the back of [1] to lock the clamp,
Speed clamps are designed to be difficult to undo once in
place, Please attach them carefully,
Use pliers to twist the clamp 90°, pulling outward, The clamp
may deteriorate over time and become damaged if removed,
When the speakers are installed at the bottom
(For PDPS045HD/4345HD only)
Speaker cable
I
Cable binders (supplied
with the stand)*
Speaker cable
*Cable binder
Using the cable binders supplied with the stand, put the
speaker and system cables together so that the cables are
invisible from the front, At that time be careful not to apply
any force to the connection sections of the cables,
ER