Kyocera KM-2530 Operation Manual page 91

2. Windows KX Driver
G Hard Disk
Perform this setting when the optional Hard Disk is installed.
In order to register a Virtual Mailbox, put a check mark in the checkbox next to [Hard Disk] and then double-click on the [Optional Hard
Disk] name to access the [Hard Disk Settings] dialog box.
G RAM Disk
Perform this setting when you want to create a RAM disk. Refer to "Chapter 1, 4-8 RAM Disk settings" on page 4-25 for more detailed
information on creating a RAM disk.
* In order to create a RAM disk, it is necessary to increase the memory capacity of your printer. After increasing memory, perform the
setting here according to the "Memory" setting below.
I Memory
Specifies the amount of memory installed in the printer. If you make a mistake in the setting here, it is possible that printing will not be
accomplished properly.
I RAM Disk
Specifies the amount of memory to be used for the RAM disk. This setting will only be available when you have selected "RAM Disk" in the
"Device Options" list.
I User...
Click on this button when you want to register a user and/or department name. The [User Settings] dialog box will appear. It is also
possible to select the "GDI compatible mode" from that dialog box. Refer to "2-7-1 User Settings" on page 2-17 for more detailed
information.
I Administrator...
Click on this button when Copy Management is Turned ON in the printer. The [Administrator Settings] dialog box will appear. Refer to
"2-7-2 Administrator Settings" on page 2-17 for more detailed information.
2-16