Xerox 3450B - Phaser B/W Laser Printer Service Manual page 131

6.
Pull out on the top of the bearing retainer on both sides of the printer to free the
tab from the retaining hole in the chassis, then rotate the bearings to the rear to
remove them from the shaft.
7.
Slide the shaft towards the right side far enough to free the left end of the shaft as
shown by ➀ below.
8.
Pull the left end of the shaft forward while sliding the right end of the shaft free
as shown by ➁ below. Remove the Pick Up Assembly from the printer.
8-34
1
Phaser 3450 Laser Printer Service Manual
s3450-070
2
s3450-072