Viewing Equipment Status - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

Error Type
frjt
fbsy

Viewing equipment status

You can display status for fans, power supply, and temperature.
NOTE: The number of fans, power supply units, and temperature sensors depends on the switch type. For
detailed specifications on these components, refer to the switch install guide.
The specific output from the status commands varies depending on the switch type.
To display the status of the fans
1. Connect to the switch and log in as admin.
2. Enter the fanShow command:
switch:admin> fanshow
Fan 1 is OK
Fan 2 is OK
Fan 3 is OK
Fan 4 is OK
Fan 5 is OK
Fan 6 is OK
switch:admin>
The possible status values are:
OK—Fan is functioning correctly.
Absent—Fan is not present.
Below minimum—Fan is present but rotating too slowly or stopped.
Above minimum—Fan is rotating too quickly.
Unknown—Unknown fan unit installed.
FAULTY—Fan has exceeded hardware tolerance.
To display the status of a power supply
1. Connect to the switch and log in as admin.
2. Enter the psShow command:
switch:admin> psshow
Power Supply #1 is OK
0335,FF2Z0007161,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007161
Power Supply #2 is faulty
0335,FF2Z0007176,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007176
switch:admin>
The possible status values are:
OK—Power supply functioning correctly.
Absent—Power supply not present.
Unknown—Unknown power supply unit installed.
Predicting failure—Power supply is present but predicting failure.
FAULTY—Power supply is present but faulty (no power cable, power switch turned off, fuse blown, or
other internal error).
Description
Frames rejected with F_RJT
Frames busied with F_BSY
speed is 7010 RPM
speed is 7180 RPM
speed is 7068 RPM
speed is 7116 RPM
speed is 7155 RPM
speed is 7001 RPM
Fabric OS 5.2.x administrator guide 273