Viewing Routing Path Information - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

Viewing routing path information

The topologyShow and uRouteShow commands provide information about the routing path.
1. Connect to the switch and log in as admin.
2. Enter the topologyShow command to display the fabric topology, as it appears to the local switch.
The following entries appear:
switch:admin> topologyshow
4 domains in the fabric; Local Domain ID: 2
Domain:
Metric:
Name:
Path Count:
Hops:
Out Port:
In Ports:
Total Bandwidth:
Bandwidth Demand:
Flags:
switch:admin>
Local Domain ID
Domain
Metric
Name
Path Count
Hops
Out Port
In Ports
Total Bandwidth
Bandwidth Demand
Flags
3. Use the uRouteShow command to display unicast routing information.
4/16 SAN Switch and 4/8 SAN Switch, SAN Switch 2/8V, SAN Switch 2/16V, SAN
Switch 2/32, SAN Switch 4/32, 4/64 SAN Switch and 400 MP Router: Use the following
syntax:
urouteshow [
194 Routing traffic
1
10500
fcr_xd_1_1
1
2
39
35 56
4.000 Gbps
300 %
D
Domain number of the local switch.
Domain number of the destination switch.
Cost of reaching the destination domain.
The name of the destination switch.
The number of currently active paths to the destination domain.
The maximum number of switch-to-switch links (ISLs) transversed to
reach the destination domain.
The Port to which the incoming frame will be forwarded in order to
reach the destination domain.
Input ports that use the corresponding Out Port to reach the
destination domain.
The maximum bandwidth of the out port.
The maximum bandwidth demand of the in ports.
Always "D", indicating a dynamic path.
portnumber domainnumber
][, ]