Wan Tool Ipperf Syntax - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

To start an ipPerf session
1. Configure the receiver test endpoint using the CP CLI.
The syntax for invoking the receiver test endpoint using ipPerf for slot8, port ge0 on an FR4- 1 8i is as
follows:
portcmd --ipperf 8/ge0 -s 192.168.255.10 -d 192.168.255.100 -R
2. Configure the sender test endpoint using a similar CP CLI.
The syntax for invoking the sender test endpoint using ipPerf for slot8, port ge0 on an FR4- 1 8i is as
follows:
portcmd --ipperf 8/ge0 -s 192.168.255.100 -d 192.168.255.10 –S
3. Use the portCmd ipPerf option specifying the slot and port of a switch.
The following example shows the results of the performance analysis for slot 8, port ge0:
ipperf to 192.168.255.10 from IP interface 192.168.255.100 on 8/0:3227
30s: BW:113.03MBps WBW(30s): 55.39MBps
60s: BW:108.89MBps WBW(30s): 83.08MBps
90s: BW:112.59MBps WBW(30s): 96.93MBps
120s: BW:108.93MBps WBW(30s): 103.85MBps
150s: BW:112.36MBps WBW(30s): 107.32MBps
In the example above, BW represents Bandwidth and Delay represents the round-trip-time (RTT) in
milliseconds. The output is printed after each display interval (if you do not specify an interval, the
default is 30 seconds). In the output, data is displayed as follows:
• First column—Time elapsed since the start of the test.
• Second column—Bandwidth observed in the last display interval using the following units:
• MBps—megabytes per second.
• Mbps—megabits per second
• KBps—kilobytes per second
• Kbps—kilobits per second
• Bps—bytes per second
• bps—bits per second
• Third column—The 30s weighted bandwidth

WAN Tool IpPerf syntax

When using the portCmd ipPerf option, you must specify the following:
• Source IP address. If the ipPerf is started with –S (source mode), the port number specified is the
remote peer's port number to connect to.
• Destination IP address
• Source (transmitter) or sink (receiver). If the ipPerf is started with –R (sink mode), the port number and
source IP address will be used to listen for new connections.
If the options are not specified the following defaults apply:
• Default port —3227
• Default runtime —forever
• Default display (refresh) interval —30 seconds
• Default size —1MSS
392 Configuring and monitoring FCIP tunneling
Loss(%):0.0 Delay(ms):1 PMTU:1500
Loss(%):0.0 Delay(ms):0 PMTU:1500
Loss(%):0.0 Delay(ms):0 PMTU:1500
Loss(%):0.0 Delay(ms):0 PMTU:1500
Loss(%):0.0 Delay(ms):0 PMTU:1500