Powering Up And Connecting Cables To The Switch; Powering Up And Connecting Cables For Serial Setup - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

The EZSwitchSetup wizard launches, as shown in
the switch's IP address using an Ethernet connection to your LAN or a serial connection.
FIGURE 4

Powering up and connecting cables to the switch

The next step is to power up and connect cables to the switch, as directed by the EZSwitchSetup
wizard.
connection.
connection to your LAN to setup your switch.
The Ethernet and serial port locations may vary between switch models. Refer to your hardware
documentation for exact locations.

Powering up and connecting cables for serial setup

1. Connect the power cord to the switch and plug in to a power source.
2. Connect an Ethernet cable from the Brocade switch to the LAN through an Ethernet hub or
EZSwitchSetup Administrator's Guide
53-1000607-02
EZSwitchSetup Wizard
Figure 5 on page 8 shows an example of cabling a Brocade switch using the serial
Figure 6 on page 9 shows an example of cabling a Brocade switch using an Ethernet
The switch power and status LEDs display amber and then change to green, which usually
takes from one to three minutes. See your switch hardware manual for the location of the
LEDs.
switch.

Powering up and connecting cables to the switch

Figure 4 and gives you a choice between setting
2
7