Setting The Switch Ip Addresses Using An Ethernet Connection11 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

5. Click Continue on the Confirmation screen.
Setting the switch IP addresses using an Ethernet connection
1. Verify that all cables are securely connected.
2. From the drop-down list (see
EZSwitchSetup Administrator's Guide
53-1000607-02
FIGURE 7 EZSwitchSetup Confirmation Step
A browser window opens and loads the EZSwitchSetup switch configuration wizard. This
process may take a few minutes. The wizard launches and the Switch Configuration Welcome
screen is displayed.
If EZSetup does not launch, you must launch it manually by specifying the URL in a browser:
http://<switch-ip>
If the switch discovery fails, see
numbers and then enter the last six alphanumeric digits of your switch's WWN. Each two
alphanumeric digits has to be separated by a colon.
To locate the WWN for your switch, refer to
Setting the switch IP address
Table 2 on page 15 for details on how to recover your switch.
Figure 8 on page 12), choose the Brocade switch's WWN prefix
"Getting technical help"
2
on page ix.
11