FIGURE 14
Connecting devices and completing the setup
1. Install the small form factor pluggable (SFP) transceivers in the Fibre Channel ports shown
EZSwitchSetup Administrator's Guide
53-1000607-02
Configure Ports and Connect Devices Screen
onscreen. (See
Figure 15
a. Remove any protector plugs from the SFP transceivers to be used.
b. Position and insert each SFP transceiver as required (right side up in the top row of ports
and upside down in the bottom row of ports) until it is firmly seated.
c.
Close the latching bale.
Connecting devices and completing the setup
on page 20).
2
19