HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 69

Data miscompare during path failover in active/passive array.
I/O timeouts observed during first time re-key of disk LUNs
Adding a tapepool (commit) cause hacluster failover even the
(container owner) switch is still disabled.
Error message may be seen on console under heavy utilization of in-
terface to key vault.
Re-key starts and host IO is blocked on failover/failback with mis-
matched time on EE nodes.
FOS-FVT- Check Condition Not Propagated On Read to Physical Initi-
ator (PI).
FCIP tape pipelining does not propagate task retry identification (TRI).
Several harmless messages gets generated when DCFM tries to discover
a large fabric.
During stress-to-fail testing of Cold Start/Recovery on a switch with
multiple Logical Switches, the local Name Server misses some device
entries.
Same device ( WWN ) is visiable in more than 2 fabric using VF
function and VT not getting imported.
Port Auto Disable - Wrong message when disabling port auto disable.
After few hafailovers, FC fast write I/O times out and a few unexpected
frame drops are seen on 1 to 2 ports out of 7-8 ports running.
Desired distance is editable for the long distance mode L0:Normal
initially when the page loads.
Fabric OS 6.3.0a fixes
Table 10 lists defects closed in the Fabric OS 6.3.0a firmware release.
Table 10 Fabric OS 6.3.0a closed defects
Switch panic occurs due to Out Of Memory condition when manage-
ment application issues repeated FCR LUN emulation queries via SMI,
or when polling a switch that had its password changed multiple times.
Closed defect summary
HP StorageWorks Fabric OS 6.3.0c Release Notes
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Disable FCIP Tapepipelining.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Perform switchdisable/enable on the
affected switches.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
Disable FCFW feature or limit the
number of HA Failover sequences to
times when IO is not active.
Fixed in Fabric OS 6.3.0
Solution
Fixed in Fabric OS 6.3.0a
Workaround prior to code change:
Disable SMI agents.
69