HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 48

DC SAN Director-upgrade from 6.1.1a to 6.2.0, hit FFDC, then panic-
detected termination of process pdmd:2676.
Pending Merge: Encryption SAN Switch Faulty during reboot -f test.
SNMPd core file filled up the root file system on the DC04 SAN Direct-
or.
Continuously disconnecting and reconnecting the ISLs in the HA envir-
onment causes one of the Encryption SAN Switches to go into faulty
state.
Command fddcfg fabwideset and other security commands fail
with RCS transaction error.
With tape pipelining active, the switch may return a good status without
sending data.
DC SAN Director ASIC parity errors, ICL CRC's and IFCC's on
overnight workload.
Host detecting IFCCs errors to CUP Port.
Sshd allows admin login to execute root level Linux commands but not
admin CLI commands.
Encryption SAN Switch goes faulty as a result of alternately rebooting
the two Encryption SAN Switches that have all the physical connectiv-
ities to the targets and initiators.
Encryption SAN Switch went Faulty when starting traffic.
SAK/IRNDUP fails with Port Address Name miscompare on CUP Port
x'FE'
Detected termination of process fabricd:4820
Pending Merge: Disconnecting and reconnecting the ISL on Encryption
SAN Switch while rekey in progress may result in new key creation
failure.
Encryption SAN Switch shows Encryption Engine busy when continu-
ously and repeatedly disabling and enableing I/O sync ports of the
Encryption SAN Switch.
48
Fixed in Fabric OS 6.3.0
Workaround prior to code change:
CPs were not in sync when
downgrading to 6.1.1a. Did net
install on DC SAN Director to 6.1.1a
and upgrade to 6.2.0b.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Workaround prior to code change: A
workaround to facilitate execution of
admin level CLI commands using ssh,
is to use syntax similar to: ssh -l admin
192.168.1.12 "rbash --login -c
'switchshow'" Or if a command is
needed that works on both older
(correctly operating) Fabric OS and
the newer/affected FOS: ssh -l admin
192.168.1.12 "switchshow || rbash
--login -c 'switchshow'"
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0