HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 55

Hp storageworks fabric os 6.3.0c release notes (5697-0301, january 2010)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

In an FCR environment, switch runs out of memory when connected
with EoS switches.
Blades are not shown in when a slot is hot plugged in to a DC SAN
Director or DC04 SAN Director.
With VF, deleting a FID while in the FID leads to undesirable conditions.
The user is stuck in the FID and all commands run generate an error
message.
Fabric OS still reports some FRU failures as link incidents on port 0xFF.
After FCoE login, Fabric OS 6.1.2_cee does not filter packets with
SRC-MAC=FCF-MAC.
Reboot of all 4 nodes in an Encryption Group (EG) with multiple rekeys
pending resulted in new rekey sessions being unable to start.
IPFC address is shown instead of chasis IP address in SNMP Trap for
DC04 SAN Director.
Required detailed error description while the port enable/disable fails.
Man page/online help on fcoelogingroup --create xxx should
replace allow-all by "allowall."
Pathinfo command failure occurs when run on Fabric OS 6.1, if
the path traverses through Fabric OS 6.2.x.
2408 FCoE CN Switch should be able to set enable password.
When Quality of Service (QoS) is enabled by default or not utilized,
performance of the SAN drops. Disable QoS by default on 4 Gb
platforms, 8 Gb long-distance and make portcfg values such as fill
words, trunk information persistent across upgrade/downgrades.
Detected termination of 0.weblinker.fcg:1315.
LUN state became disabled with reason "Key not in sync" after 12
hour run of stress test KV link failure/restore with online rekey.
Devices attached to AG are not considered as Virtual.
Persistently disabled GE port on a Multiprotocol Router Blade becomes
disabled after hafailover.
rcsd terminated on 8/80 SAN Switch during a configDownload
on all switches in the fabric.
Key id sate shows "key expired: Allowing data append" while key
lifespan = 0 minute.
Rekey operation is restarted but hung after all the Encryption Engines
(EEs) in the encryption group are rebooted.
LUN state shows target offline after disconnect/reconnected both initi-
ator and target.
Containers for 4/32B SAN Switch not ready for discover LUN.
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
Fixed in Fabric OS 6.3.0
HP StorageWorks Fabric OS 6.3.0c Release Notes
55

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae370a - brocade 4gb san switch 4/12

Table of Contents