Dell PowerConnect B-DCX-4S Backbone Hardware Reference Manual page 78

5
RRP: WWN card
6. Wait until all the LEDs on the WWN card turn off.
7.
8. Disconnect the WWN cable by depressing the cable connector latch and pulling the connector
9. Set the WWN card on a static-free surface, such as a grounding pad.
FIGURE 28
'
64
Do you wish to continue [y/n]? y
Backing up WWN card data, please wait about 25 seconds for further
instruction.
Please install the new FRU now.
If this session lost for any reason, please re-enter the frureplace command
and
follow the instructions to complete the operation.
Please enter the word `continue' after the new WWN card has been installed:
Use a Phillips screwdriver to unscrew the screw that secures the WWN card to the chassis. Use
the pull tab to remove the card.
from the WWN module.
RRP: WWN bezel (logo plate) and WWN card
PowerConnect B-DCX-4S Backbone Hardware Reference Manual
53-1001808-01