Dell PowerConnect B-DCX-4S Backbone Hardware Reference Manual page 88

5
RRP: PowerConnect B-DCX-4S chassis
TABLE 13
Output from supportshow command
Information about the new chassis
1. Open a Telnet session and log in to the PowerConnect B-DCX-4S as admin. The default
2. Back up the current configuration.
•
•
3. Record the PowerConnect B-DCX-4S values on a workstation
4. Record the WWN value: Enter wwn; then, copy the command output into a file named
5. Record the IP address information.
74
Critical information checklist (Continued)
Location of "spptshow.txt" file
Notes regarding supportshow output
New Factory Serial Num
New Serial Num (if available)
password is password. Enable the logging function on your Telnet or serial console connection.
NOTE
If you are using the virtual fabric feature, you should run configupload -vf before running the
configupload command in order to save the logical switch configuration.
Enter configUpload -all; then, enter the requested information at the prompts.
This command uploads the PowerConnect B-DCX-4S configuration to the customer-defined FTP
server, making it available for downloading. For more information about this command, refer to
the Fabric OS Command Reference.
switch:admin> configupload
Protocol (scp or ftp) [ftp]: ftp
Server Name or IP Address [host]: 123.123.123.123
User Name [user]: Admin24
File Name [config.txt]: config-switch0.txt
Password: xxxxxxxx
Upload complete
switch:admin>
Alternatively, you can save the configuration file to a Brocade USB.
"config-miscinfo.txt".
switch:admin> wwn
10:00:00:60:69:00:00:0a
Enter ipAddrShow -sw; then, copy the command output into the "config-miscinfo.txt" file.
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 10.32.50.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
(step 4
PowerConnect B-DCX-4S Backbone Hardware Reference Manual
through step 9).
53-1001808-01