Clearing And Resetting Interfaces And Counters; Shutting Down And Restarting The Interface - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Chapter 9 Configuring the Switch Interfaces

Clearing and Resetting Interfaces and Counters

Table 9-3
interfaces.
Table 9-3 Clear Commands for Interfaces
Command
clear counters [interface-id]
clear interface interface-id
clear line [number | console 0 | vty number]
To clear the interface counters shown by the show interfaces privileged EXEC command, use the clear
counters privileged EXEC command. The clear counters command clears all current interface counters
from the interface unless optional arguments are specified to clear only a specific interface type from a
specific interface number.
The clear counters privileged EXEC command does not clear counters retrieved by using Simple
Note
Network Management Protocol (SNMP), but only those seen with the show interfaces privileged EXEC
command output.
This example shows how to clear and reset the counters on Fast Ethernet interface 0/5:
Switch# clear counters fastethernet0/5
Clear "show interface" counters on this interface [confirm] y
Switch#
*Sep 30 08:42:55: %CLEAR-5-COUNTERS: Clear counter on interface FastEthernet0/5
by vty1 (171.69.115.10)
Use the clear interface or clear line privileged EXEC command to clear and reset an interface or serial
line. Under most circumstances, you do not need to clear the hardware logic on interfaces or serial lines.
This example shows how to clear and reset Fast Ethernet interface 0/5:
Switch# clear interface fastethernet0/5

Shutting Down and Restarting the Interface

Shutting down an interface disables all functions on the specified interface and marks the interface as
unavailable on all monitoring command displays. This information is communicated to other network
servers through all dynamic routing protocols. The interface is not mentioned in any routing updates.
Beginning in privileged EXEC mode, follow these steps to shut down an interface:
Command
Step 1 configure terminal
Step 2 interface {vlan vlan-id} | {{fastethernet | gigabitethernet |
longreachethernet} interface-id} | {port-channel
port-channel-number}
Step 3 shutdown
78-14982-01
lists the clear privileged EXEC commands that you can use to clear counters and reset
Purpose
Clear interface counters.
Reset the hardware logic on an interface.
Reset the hardware logic on an asynchronous serial line.
Monitoring and Maintaining the Interfaces
Purpose
Enter global configuration mode.
Select the interface to be configured.
Shut down an interface.
Catalyst 2950 Desktop Switch Software Configuration Guide
9-19