Configuring Extended-Range Vlans; Default Vlan Configuration; Extended-Range Vlan Configuration Guidelines - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Configuring Extended-Range VLANs

Configuring Extended-Range VLANs
When the switch is in VTP transparent mode (VTP disabled) and the EI is installed), you can create
extended-range VLANs (in the range 1006 to 4094). Extended-range VLANs enable service providers
to extend their infrastructure to a greater number of customers. The extended-range VLAN IDs are
allowed for any switchport commands that allow VLAN IDs. You always use config-vlan mode
(accessed by entering the vlan vlan-id global configuration command) to configure extended-range
VLANs. The extended range is not supported in VLAN configuration mode (accessed by entering the
vlan database privileged EXEC command).
Extended-range VLAN configurations are not stored in the VLAN database, but because VTP mode is
transparent, they are stored in the switch running configuration file, and you can save the configuration
in the startup configuration file by using the copy running-config startup-config privileged EXEC
command.
Note Although the switch supports 4094 VLAN IDs when the EI is installed, see the
section on page 14-2
This section includes this information about extended-range VLANs:
•
•
•
•

Default VLAN Configuration

See
MTU size on extended-range VLANs; all other characteristics must remain at the default state.

Extended-Range VLAN Configuration Guidelines

Follow these guidelines when creating extended-range VLANs:
•
•
•
•
•
•
Catalyst 2950 Desktop Switch Software Configuration Guide
14-12
for the actual number of VLANs supported.
Default VLAN Configuration, page 14-12
Extended-Range VLAN Configuration Guidelines, page 14-12
Creating an Extended-Range VLAN, page 14-13
Displaying VLANs, page 14-14
Table 14-2 on page 14-8 for the default configuration for Ethernet VLANs. You can change only the
To add an extended-range VLAN, you must use the vlan vlan-id global configuration command and
access config-vlan mode. You cannot add extended-range VLANs in VLAN configuration mode
(accessed by entering the vlan database privileged EXEC command).
VLAN IDs in the extended range are not saved in the VLAN database and are not recognized by
VTP.
You cannot include extended-range VLANs in the pruning eligible range.
The switch must be in VTP transparent mode when you create extended-range VLANs. If VTP mode
is server or client, an error message is generated, and the extended-range VLAN is rejected.
You can set the VTP mode to transparent in global configuration mode or in VLAN configuration
mode. See the "Disabling VTP (VTP Transparent Mode)" section on page
this configuration to the startup configuration so that the switch will boot up in VTP transparent
mode. Otherwise, you will lose extended-range VLAN configuration if the switch resets.
VLANs in the extended range are not supported by VQP. They cannot be configured by VMPS.
Chapter 14 Configuring VLANs
"Supported VLANs"
15-12. You should save
78-14982-01