Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 90
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Menus and Toolbar
Table 3-17 Device Popup Menu of a Command-Switch Icon
Popup Menu Option
Collapse cluster
Host Name
Bandwidth Graphs
Properties
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
Modes in CMS" section on page
Table 3-18 Device Popup Menu of a Member or Standby Command-Switch Icon
Popup Menu Option
Remove from Cluster
Host Name
Device Manager
Bandwidth Graphs
Properties
1. Available only from a cluster-management session.
2. Available from a cluster member switch but not from the command switch.
Table 3-19 Device Popup Menu of a Candidate-Switch Icon (When the Candidate Switch Has an
Popup Menu Option
Add to Cluster
Device Manager
Properties
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
Modes in CMS" section on page
2. Available from a cluster member switch but not from the command switch.
Table 3-20 Device Popup Menu of a Candidate-Switch Icon (When the Candidate Switch Does Not
Popup Menu Option
Add to Cluster
Properties
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
Modes in CMS" section on page
Catalyst 2950 Desktop Switch Software Configuration Guide
3-24
Task
View the neighborhood outside a specific cluster.
1
Change the host name of a switch.
Display graphs that plot the total bandwidth in use by the switch.
Display information about the device.
3-31.
Task
1
Remove a member from the cluster.
1
Change the host name of a switch.
2
Launch Device Manager for a switch.
Display graphs that plot the total bandwidth in use by the switch.
Display information about the device.
IP Address)
Task
1
Add a candidate to a cluster.
2
Launch Device Manager for a switch.
Display information about the device.
3-31.
Have an IP Address)
Task
1
Add a candidate to a cluster.
Display information about the device.
3-31.
Chapter 3
Getting Started with CMS
"Access
"Access
"Access
78-14982-01
Advertisement
Table of Contents
Troubleshooting
