Displaying Span And Rspan Status - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Displaying SPAN and RSPAN Status

Displaying SPAN and RSPAN Status
To display the status of the current SPAN or RSPAN configuration, use the show monitor privileged
EXEC command.
This is an example of output for the show monitor privileged EXEC command for RSPAN source
session 1:
Switch# show monitor session 1
Session 1
---------
Type: Remote Source Session
Source Ports:
Source VLANs:
Source RSPAN VLAN: None
Destination Ports: None
Reflector Port:
Filter VLANs:
Dest RSPAN VLAN: 901
Catalyst 2950 Desktop Switch Software Configuration Guide
21-20
RX Only: Fa0/3
TX Only: None
Both: None
RX Only: None
TX Only: None
Both: None
Encapsulation: Native
Fa0/4
None
Chapter 21 Configuring SPAN and RSPAN
78-14982-01