Assigning Static-Access Ports To A Vlan - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Chapter 14 Configuring VLANs

Assigning Static-Access Ports to a VLAN

You can assign a static-access port to a VLAN without having VTP globally propagate VLAN
configuration information (VTP is disabled). If you are assigning a port on a cluster member switch to
a VLAN, first use the rcommand privileged EXEC command to log in to the member switch.
Note If you assign an interface to a VLAN that does not exist, the new VLAN is created. (See the
or Modifying an Ethernet VLAN" section on page
Beginning in privileged EXEC mode, follow these steps to assign a port to a VLAN in the VLAN
database:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
switchport mode access
Step 4
switchport access vlan vlan-id
Step 5
end
Step 6 show running-config interface interface-id
Step 7
show interfaces interface-id switchport
Step 8
copy running-config startup-config
To return an interface to its default configuration, use the default interface interface-id interface
configuration command.
This example shows how to configure Fast Ethernet interface 0/1 as an access port in VLAN 2:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface fastethernet0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 2
Switch(config-if)# end
Switch#
78-14982-01
14-8.)
Purpose
Enter global configuration mode
Enter the interface to be added to the VLAN.
Define the VLAN membership mode for the port (Layer 2 access
port).
Assign the port to a VLAN. Valid VLAN IDs are 1 to 4094; do not
enter leading zeros.
Return to privileged EXEC mode.
Verify the VLAN membership mode of the interface.
Verify your entries in the Administrative Mode and the Access Mode
VLAN fields of the display.
(Optional) Save your entries in the configuration file.
End with CNTL/Z.
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring Normal-Range VLANs
"Creating
14-11