Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 246

Monitoring and Maintaining the Interfaces
Operational Mode: down
<output truncated>
This example shows how to display the running configuration of Fast Ethernet interface 0/2:
Switch# show running-config interface fastethernet0/2
Building configuration...
Current configuration : 131 bytes
!
interface FastEthernet0/2
switchport mode access
switchport protected
no ip address
mls qos cos 7
mls qos cos override
end
This example shows the output of the show interfaces privileged EXEC commands for a Catalyst 2950
LRE switch:
Switch# show interfaces lo0/2
LongReachEthernet0/2 is up, line protocol is up
Hardware is Long Reach Ethernet, address is 0056.895a.7e82 (bia 0056.895a.7e82)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 2000 bits/sec, 2 packets/sec
1 packets input, 64 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
368 packets output, 33134 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
For a Catalyst 2950 LRE switch, the show interfaces privileged EXEC command for a LRE interface
Note
displays the statistics for the LRE interface rather than the statistics for the Ethernet port(s) on the CPE
device. In addition, the speed and duplex of the LRE interface is never auto-negotiated, but is always
forced (in other words, the speed and duplex will be 100 Mbps and half-duplex, 100 Mbps and
full-duplex, 10 Mbps and half-duplex, or 10 Mbps and full-duplex).
Catalyst 2950 Desktop Switch Software Configuration Guide
9-18
Chapter 9 Configuring the Switch Interfaces
78-14982-01