Topology View Popup Menus; Link Popup Menu - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Menus and Toolbar
Table 3-14 Port Popup Menu (continued)
Popup Menu Option
Link Graphs
Select All Ports
1. Some options from this menu option are not available in read-only mode.
2. Available on switches that support the Port Security feature.
3. Available only when there is an active link on the port (that is, the port LED is green when in port status mode).

Topology View Popup Menus

These popup menus are available in the Topology view.

Link Popup Menu

You can display reports and graphs for a specific link displayed in the Topology view (see
To display the link popup menu, click the link icon, and right-click.
Table 3-15 Link Popup Menu
Popup Menu Option
Link Report
Link Graph
Properties
The Link Report and Link Graph options are not available if at both ends of the link are
•
•
•
If multiple links are configured between two devices, when you click the link icon and right-click, the
Multilink Content window appears (see
to display the link popup menu specific for that link.
Catalyst 2950 Desktop Switch Software Configuration Guide
3-22
Task
3
Display a graph showing the bandwidth used by the selected link.
Select all ports on the switch for global configuration.
Task
Display the link report for two connected devices. If one device is an unknown
device or a candidate, only the cluster member side of the link displays.
Display a graph showing the current bandwidth used by the selected link. You
can change the graph polling interval by selecting CMS > Preferences.
Display information about the device and port on either end of the link and the
state of the link.
Candidate switches
Catalyst 1900 and Catalyst 2820 switches
Devices that are not eligible to join the cluster
Figure 3-12). Click the link icon in this window, and right-click
Chapter 3 Getting Started with CMS
Table 3-15).
78-14982-01