Using Debug Commands; Enabling Debugging On A Specific Feature - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Using Debug Commands

Using Debug Commands
This section explains how you use debug commands to diagnose and resolve internetworking problems.
It contains this information:
•
•
•
Caution Because debugging output is assigned high priority in the CPU process, it can render the system
unusable. For this reason, use debug commands only to troubleshoot specific problems or during
troubleshooting sessions with Cisco technical support staff. It is best to use debug commands during
periods of lower network traffic and fewer users. Debugging during these periods decreases the
likelihood that increased debug command processing overhead will affect system use.
Note For complete syntax and usage information for specific debug commands, refer to the command
reference for this release.

Enabling Debugging on a Specific Feature

All debug commands are entered in privileged EXEC mode, and most debug commands take no
arguments. For example, beginning in privileged EXEC mode, enter this command to enable the
debugging for EtherChannel:
Switch# debug etherchannel
The switch continues to generate output until you enter the no form of the command.
If you enable a debug command and no output is displayed, consider these possibilities:
•
•
To disable debugging of EtherChannel, enter this command in privileged EXEC mode:
Switch# no debug etherchannel
Alternately, in privileged EXEC mode, you can enter the undebug form of the command:
Switch# undebug etherchannel
To display the state of each debugging option, enter this command in privileged EXEC mode:
Switch# show debugging
Catalyst 2950 Desktop Switch Software Configuration Guide
28-14
Enabling Debugging on a Specific Feature, page 28-14
Enabling All-System Diagnostics, page 28-15
Redirecting Debug and Error Message Output, page 28-15
The switch might not be properly configured to generate the type of traffic you want to monitor. Use
the show running-config command to check its configuration.
Even if the switch is properly configured, it might not generate the type of traffic you want to
monitor during the particular period that debugging is enabled. Depending on the feature you are
debugging, you can use commands such as the TCP/IP ping command to generate network traffic.
Chapter 28 Troubleshooting
78-14982-01