Clearing And Resetting Interfaces And Counters - Cisco Catalyst 3750-E Software Configuration Manual

Chapter 12 Configuring Interface Characteristics
Table 12-6 Show Commands for Interfaces (continued)
Command
show interfaces transceiver properties
show interfaces [interface-id] [{transceiver
properties | detail}] module number]
show running-config interface [interface-id]
show version
show controllers ethernet-controller interface-id
phy
show power inline [interface-id | module
switch-number]
show power inline consumption
show power inline police

Clearing and Resetting Interfaces and Counters

Table 12-7
interfaces.
Table 12-7 Clear Commands for Interfaces
Command
clear counters [interface-id]
clear interface interface-id
clear line [number | console 0 | vty number]
To clear the interface counters shown by the show interfaces privileged EXEC command, use the clear
counters privileged EXEC command. The clear counters command clears all current interface counters
from the interface unless you specify optional arguments that clear only a specific interface type from a
specific interface number.
The clear counters privileged EXEC command does not clear counters retrieved by using Simple
Note
Network Management Protocol (SNMP), but only those seen with the show interface privileged EXEC
command.
OL-9775-08
Purpose
(Optional) Display temperature, voltage, or amount of current on the
interface.
Display physical and operational status about an SFP module.
Display the running configuration in RAM for the interface.
Display the hardware configuration, software version, the names and
sources of configuration files, and the boot images.
Display the operational state of the auto-MDIX feature on the
interface.
Display PoE status for a switch or switch stack, for an interface, or for
a specific switch in the stack.
Display the power consumption data.
Display the power policing data.
lists the privileged EXEC mode clear commands that you can use to clear counters and reset
Purpose
Clear interface counters.
Reset the hardware logic on an interface.
Reset the hardware logic on an asynchronous serial line.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Monitoring and Maintaining the Interfaces
12-41