Power (Command : A); Input Select (Command : B) (Main Picture Input) - HP LD4201 User Manual

[Command2][][Set ID][][NG][Data][x]
*If there is error, it returns NG

01. Power (Command : a)

To control Power On/Off of the Set.
Transmission
[k][a][][Set ID][][Data][Cr]
[Data]
Acknowledgement
[a][][Set ID][][OK][Data][x]
To show the status of Power On/Off.
Transmission
[k][a][][Set ID][][FF][Cr]
Acknowledgement
[a][][Set ID][][OK][Data][x]
[Data]

02. Input Select (Command : b) (Main Picture Input)

To select input source for the Set.
You can also select an input source using the INPUT button on the remote control.
Transmission
ENWW
2nd Draft
0 : Power Off
1 : Power On
0 : Power Off
1 : Power On
Transmission/Receiving Protocol 97