Notes On Using The Micr Reader - Epson H6000III - TM Two-color Thermal Line Technical Reference Manual

❏ To print endorsements in the specified area (within 38.1 mm {1.5"} from the top), set the
print position for the last line so that it is printed at least 3 mm {0.118"} above the bottom of
the printable area (Especially when the printer is used near the display device, the user is
required to check the recognition rate of the MICR).
NOTE:
1. Do not install the printer near any magnetic fields, because this may cause MICR reading errors. (Be sure to
check the MICR recognition rate when the printer is used near a display device.)
2. MICR characters may not be recognized when impact or vibration is applied to the printer.

1.4.4.4 Notes on using the MICR reader

❏ The personal checks must be flat, without curls, folds, or wrinkles (especially at the edges).
Otherwise, the check may rub against the ribbon and become ink-stained.
❏ Do not insert checks that have clips or staples. These may cause paper jams, MICR reading
errors, and damage to the MICR head.
❏ Let go of the check immediately as soon as the printer starts feeding it. Otherwise, the paper
is not fed straight, causing paper jams and MICR reading errors.
1-18 General Information
Specified printing aria
38.1
[Units : mm (All numeric values are typical.)]
Endorsement printing
Rev. E