Notes On Using The Micr Reader - Epson H6000II - TM Two-color Thermal Line User Manual

Use the following or an equivalent commercially available cleaning
sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD"
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load roll paper in the printer, turn off the power, then open the
roll paper cover and turn the power back on while holding
down the RELEASE button.
2. Press the RELEASE button
7 times, then close the roll
paper cover. The printer
prints the following
message on receipt paper,
and the SLIP light flashes.
3. Insert the cleaning sheet like a standard check.
Be sure that the sheet is inserted with the correct side up and that it
is inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
4. When the sheet is ejected, press the RELEASE button, and
remove the sheet from the printer.

Notes on using the MICR reader

Do not install the printer near any magnetic fields. Be especially
careful where you install your display device, and be sure to check
the recognition rate of the MICR reader with the display device in
place.
Make sure that the printer is not subjected to any impact or
vibration when it is performing a MICR reading.
Endorsement Printing
If your printer has the optional endorsement printing mechanism,
install the endorsement ribbon following the steps below:
Use the EPSON ERC-41. The use of any ribbon cassettes other than
those approved by EPSON may damage the printer and will void
the warranty.
CAUTION:
TM-H6000II with Image Scanner User's Manual 11
English