Notes On Using The Micr Reader - Epson C284999 - TM H6000P B/W Direct Thermal User Manual

User manual
Table of Contents

Advertisement

2. Press the RELEASE button 7 times; then close the paper roll
cover. The printer prints the following message on receipt
paper, and the SLIP light flashes.
3. Insert the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is
inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
4. When the sheet is ejected, press the RELEASE button, and
remove the sheet from the printer.

Notes on using the MICR reader

Do not install the printer near any magnetic fields. Be especially
careful where you install your display device, and be sure to check
the recognition rate of the MICR reader with the display device in
place.
Make sure that the printer is not subjected to any impact or
vibration when it is performing a MICR reading.
Endorsement Printing
If your printer has the optional endorsement printing mechanism,
install the endorsement ribbon following the steps below:
Use the EPSON ERC-41. The use of any ribbon cassettes other than
those approved by EPSON may damage the printer and will void
the warranty.
Note:
Be sure to turn on the power before installing a ribbon cassette.
TM-H6000 User's Manual 9
English

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tm-h6000Tm-h6000p

Table of Contents