Parallel Interface Models; Usb Interface Models - Epson H6000III - TM Two-color Thermal Line Technical Reference Manual

3.3.5.2 Parallel Interface Models

1. Press the connector on the end of the interface cable firmly into the interface connector on
the connector panel.
2. Press down the clips on either side of the connector to lock it in place.
3. For interface cables equipped with a ground line, attach the ground line to the screw hole
marked "FG" on the printer.
4. Connect the other end of the interface cable to the host computer.

3.3.5.3 USB Interface Models

1. Attach the locking wire saddle at the location shown in the figure below.
2. Hook the USB cable through the locking wire saddle, as shown in the figure below.
Note:
Hooking the USB cable through the locking wire saddle, as shown in the figure below, will prevent the
cable from coming unplugged.
3. Connect the USB cable from the host computer to the USB upstream connector.
3-16 Setup
Attaching locking wire saddle
Locking wire saddle
Rev. E