Chapter 7 Application Development For Image Scanner; The Flow Of Single Pass Processing - Epson H6000III - TM Two-color Thermal Line Technical Reference Manual

Chapter 7
Application Development for Image Scanner
This section explains key words in a question and answer format and the single-pass processing
for developing a system with the TM-H6000III with the image scanner.

7.1 The flow of single pass processing

The following figures introduce you to "smart pass processing." This processing provides you
MICR reading, slip printing (face & endorsement), and scanning a check with one time insertion.
1. When the check is inserted.
The direction the
paper has been
fed (forward).
3. Pre-scanning has been done.
(This step is required when you scan with bi-tonal data
format only)
Rev. E
MICR head
Image scanner
Application Development for Image Scanner 7-1
TM-H6000III Technical Reference Guide
The direction the
paper has been
fed (forward).
2. MICR reading is completed.
The direction
the paper has
been fed
(forward).
4. Print position for the endorsement printing has been
set (based on the bottom edge of the paper). The
area for reverse printing is limited; therefore when
setting the print area, be sure to note that the
endorsement printing cannot be done within 6.9 mm
(typical) from the bottom of the paper.
MICR head
Endorsement
head