Control Panel Assembly; Removing The Control Panel Assembly - Dell External OEMR R210II Owner's Manual

9 Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 26.
10 Enter the correct time and date in the System Setup program's Time and
Date fields.
11 Exit the System Setup program.

Control Panel Assembly

Removing the Control Panel Assembly

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 If installed, remove the front bezel. See "Removing the Front Bezel" on
page 49.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
3 Open the system. See "Opening the System" on page 50.
4 Remove hard drive 0. See "Removing a 3.5-Inch Hard Drive" on page 56.
5 Remove the internal USB key (if present). See "Internal USB Memory Key"
on page 65.
6 Disconnect the control panel cable at back of the control panel board:
CAUTION:
Do not pull on the cable to unseat the connector. Doing so can damage
the cable.
Press the metal tabs on the ends of the cable connector.
a
Gently work the connector out of the socket.
b
Remove the USB connector cable from the control panel.
c
7 Remove the four screws that secure the control panel board to the chassis
and remove the board.
Installing System Components
91