Dell External OEMR R210II Owner's Manual page 57

Figure 3-6. Removing and Installing a 3.5-Inch Hard Drive
1 hard-drive carrier
3 hard drive
5 power cable
NOTE:
If you are not replacing the hard drive, remove the drive from the hard-drive
carrier (see "Removing a 3.5-Inch Hard Drive From a Hard-Drive Carrier" on page 59)
and replace the empty hard-drive carrier back into the drive bay.
7 If you have removed or replaced HDD1, replace the optical drive (if
present) mounted above the hard-drive carrier. See "Installing an Optical
Drive" on page 54.
8 Close the system. See "Closing the System" on page 51.
9 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1
6
5
2 release pin
4 data cable
6 chassis tabs (4)
Installing System Components
2
3
4
57