Cooling Shroud - Dell External OEMR R210II Owner's Manual

NOTE:
To avoid interference with other components, the maximum allowable
dimensions of the USB key are 24 mm (0.94 in) wide x 79 mm (3.11 in) long x 8.6 mm
(0.33 in) high.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 50.
3 Locate the USB connector on the control panel board. See Figure 3-20.
4 Insert the USB memory key into the USB connector.
5 Close the system. See "Closing the System" on page 51.
6 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Figure 3-10. Removing and Installing a USB Memory Key
1 USB memory key connector

Cooling Shroud

The cooling shroud covers the processor, heat sink, and memory modules, and
provides airflow to these components. Airflow is facilitated by the cooling fan
modules, which are positioned directly behind the cooling shroud.
66
Installing System Components
1
2
2 USB memory key