Disabling A Forgotten Password - Dell External OEMR R210II Owner's Manual

Disabling a Forgotten Password

The system's software security features include a system password and a setup
password, which are discussed in detail in "Using the System Setup Program
and Boot Manager" on page 25. The password jumper enables these password
features or disables them and clears any password(s) currently in use.
CAUTION:
instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 50.
3 Remove the jumper plug from the password jumper.
See
Figure 6-1
the system board.
4 Close the system.
5 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
The existing passwords are not disabled (erased) until the system boots
with the password jumper plug removed. However, before you assign a new
system and/or setup password, you must install the jumper plug.
NOTE:
still removed, the system disables the new password(s) the next time it boots.
6 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7 Open the system. See "Opening the System" on page 50.
8 Install the jumper plug on the password jumper.
9 Close the system. See "Closing the System" on page 51.
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning
a Setup Password" on page 42.
118
Jumpers and Connectors
See "Protecting Against Electrostatic Discharge" in the safety
to locate the password jumper (labeled "PWRD_EN") on
If you assign a new system and/or setup password with the jumper plug