Configuring Bims Server Information For The Client; Configuring Gateways For The Client - HP A7500 Series Configuration Manual

You can specify up to eight WINS servers in a DHCP address pool.
You must also specify a NetBIOS node type in a DHCP address pool. There are four NetBIOS node
types:
b (broadcast)-node: The b-node client sends the destination name in a broadcast message. The
•
destination returns its IP address to the client after receiving the message.
p (peer-to-peer)-node: The p-node client sends the destination name in a unicast message to the
•
WINS server, and the WINS server returns the destination IP address.
m (mixed)-node: A combination of broadcast first and peer-to-peer second. The m-node client first
•
broadcasts the destination name. If it receives no response, it unicasts the destination name to the
WINS server to get the destination IP address.
h (hybrid)-node: A combination of peer-to-peer first and broadcast second. The h-node client
•
unicasts the destination name to the WINS server. If it receives no response, it broadcasts the
destination name to get the destination IP address.
Follow these steps to configure WINS servers and NetBIOS node type in the DHCP address pool:
To do...
Enter system view
Enter DHCP address pool view
Specify WINS server IP addresses
Specify the NetBIOS node type
NOTE:
If b-node is specified for the client, you do not need to specify any WINS server address.

Configuring BIMS server information for the client

The DHCP server must provides DHCP clients with the branch intelligent management system (BIMS)
server IP address, port number, shared key from the DHCP address pool, to enable DHCP clients to
perform regular software update and backup by using configuration files obtained from a BIMS server.
Follow these steps to configure the BIMS server IP address, port number, and shared key in the DHCP
address pool:
To do...
Enter system view
Enter DHCP address pool view
Specify the BIMS server IP address,
port number, and shared key

Configuring gateways for the client

You can specify up to eight gateways in a DHCP address pool.
Use the command...
system-view
dhcp server ip-pool pool-name
[ extended ]
nbns-list ip-address&<1-8>
netbios-type { b-node | h-node
| m-node | p-node }
Use the command...
system-view
dhcp server ip-pool pool-name
[ extended ]
bims-server ip ip-address [ port
port-number ] sharekey key
42
Remarks
—
—
Required (optional for b-node)
No address is specified by default.
Required
Not specified by default.
Remarks
—
—
Required
Not specified by default.