Paper Guide / Platen Assembly Removal - Lexmark 2380 - Forms Printer B/W Dot-matrix Service Manual

Paper Guide / Platen Assembly Removal

1. Remove the tractor assembly
see "Push Tractor Assembly Removal" on page
2. Remove the top cover
see "Top Cover Removal" on page
3. Remove the pull tractor actuator
see "Pull Tractor Actuator Removal" on page
4. Remove the paper select lever
see "Paper Select Lever Removal" on page
5. Remove the printhead
see "Printhead Removal" on page
6. Remove the sub logic board
see "Sub Logic Board Removal" on page
7. Remove the paper feed motor
see "Paper Feed Motor Removal" on page
8. Remove the carrier see
9. Remove the tractor idler gear.
10. 23XX-001 - Remove the platen bar screw that was covered by
the gear.
23XX-002, 003 - Remove the rear support plate mounting screw
that was covered by the gear. Remove the metal support plate
mounting screw and the support plate. Remove the platen bar
screw that was covered by the support plate.
11. Remove the upper feed roller
see "Upper Feed Roller Removal" on page
12. Remove the lower pinch roller
see "Lower Pinch Roller Removal" on page
13. Remove the gears on the side frame (right)
see "Right Side Frame Gears Removal" on page
14. Remove the print unit see
15. Remove the right side frame
see "Right Side Frame Removal" on page
16. Remove the lower feed roller
see "Lower Feed Roller Removal" on page
17. Release the two latches [1] on the left side of the paper guide
[2], and then remove the assembly from the left side frame.
18. Perform the Printhead-to-Platen Gap adjustment
see "Printhead-to-Platen Gap Adjustment" on page
4-40
4-61.
4-48.
"Carrier Removal" on page
"Print Unit Removal" on page
4-53.
4-51.
4-42.
4-59.
4-38.
4-12.
4-66.
4-32.
4-58.
4-47.
4-56.
4-30.
4-2.