Bidirectional Print Adjustment - Lexmark 2380 - Forms Printer B/W Dot-matrix Service Manual

Bidirectional Print Adjustment

After replacing any mechanical part which affects the operation of
the main logic board or the carrier, perform the following procedure
to adjust the bidirectional print.
Note: This adjustment cannot be completed if the printer runs out of
paper, so be sure to use continuous forms.
1. Be sure the ribbon cartridge and continuous forms are installed.
2. Turn the printer on.
3. Press Alt and then press Micro . The printer enters Setup
Mode.
4. Press the Control Options button. (Button varies with model.)
5. Press the Bidirectional Alignment button. (Button varies with
model.)
6. Press Font. The printer prints out the pattern shown below. The
first and third lines are printed from left to right. The second and
fourth lines are printed from right to left.
Repair Information 4-5