Lexmark 2380 - Forms Printer B/W Dot-matrix Service Manual page 78

7. Move the carrier so that it is just to the right of the right upper
feed roller, approximately 50 mm (2.0 in.) from the right side
frame.
8. Using feeler gauges [1] of 0.35 mm and 0.40 mm (0.014 in. and
0.016 in.), move the right carrier bushing [2] forward or
backward until the gap between the printhead [3] and platen [4]
is between 0.35 mm - 0.40 mm (0.014 in. - 0.016 in.).
Note: The gap should be wide enough for the 0.35 mm (0.014 in.)
feeler gauge to slide in smoothly without catching, but too narrow to
insert the 0.40 mm (0.016 in.) feeler gauge.
9. Repeat Steps 5 and 6 and readjust the gap if necessary.
10. Repeat Steps 7 and 8 and readjust the gap if necessary.
11. Set the form thickness lever to suit the paper thickness you are
using.
12. Install the ribbon cartridge and paper.
13. Install the ribbon access cover.
14. Run the self test and check the density of the printing. Repeat
procedure if necessary.
4-4