Removing A Memory Module - IBM x3105 - System - 4347 Service Manual

Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps.
DIMM
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all peripheral devices; then, disconnect the power cords
3. Remove the cover (see "Removing the cover" on page 61).
4. Disconnect any cables that impede access to the DIMMs.
5. Carefully open the retaining clips on each end of the DIMM connector and
6. If you are instructed to return the DIMM, follow all packaging instructions, and
on page 59.
and all external cables.
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
remove the DIMM.
use any packaging materials for shipping that are supplied to you.
Retaining
clip
Chapter 4. Removing and replacing server components
67