Installing the microprocessor and heat sink
To install the microprocessor and heat sink, complete the following steps.
Heat-sink retention
lever
1. Make sure that the microprocessor socket lever is in the fully open position.
2. Install the microprocessor by using the vacuum tool and completing the
88
IBM System x3105 Type 4347: Problem Determination and Service Guide
Orientation indicators
Attention:
Use the vacuum tool that comes with the replacement part to
install the microprocessor. Dropping the microprocessor during installation can
damage the contacts. Also, contaminants on the microprocessor contacts, such
as oil from your skin, can cause connection failures between the contacts and
the socket.
following steps.
Microprocessor heatsink
Microprocessor