Installing the bezel assembly
The following illustration shows how to install the blade server bezel assembly. The
procedure for installing the MPE bezel assembly is the same, except that the MPE
does not have a control-panel connector.
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. If you are installing the bezel assembly on a blade server, connect the
3. Carefully slide the bezel assembly onto the blade server or MPE until it clicks
"Installation guidelines" on page 17.
control-panel cable to the control-panel connector on the system board. If you
are installing the bezel assembly on an MPE unit, go to step 3.
Note: Align the control-panel cable with the notch in the air baffle on the blade
server in front of the control-panel connector.
into place.
Chapter 3. Installing optional devices
47