Removing The Bezel Assembly - IBM LS42 - BladeCenter - 7902 Installation And User Manual

Removing the bezel assembly

To install certain optional devices, you must first remove the bezel assembly. The
following illustration shows how to remove the blade server bezel assembly. The
procedure for removing the MPE bezel assembly is the same, except that the MPE
does not have a control-panel connector.
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. Remove the blade server cover (see "Opening the blade server cover" on page
3. If you are removing the bezel assembly from the blade server and an MPE unit
4. Press the bezel-assembly release and pull the bezel assembly away from the
5. If you are removing the bezel assembly from the blade server, disconnect the
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.
22
BladeCenter LS22 and LS42 Type 7901 and 7902: Installation and User's Guide
"Installation guidelines" on page 17.
20 for instructions).
or an expansion unit is connected to the blade server, remove the expansion
unit (see "Removing an expansion unit" on page 21).
blade server approximately 1.2 cm (0.5 inch).
control-panel cable by lifting the cable from the control-panel connector. If you
are removing a bezel assembly on an MPE unit, go to step 6.