Standby Mode; Schedule - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

9 ) Display the internal test pattern [ALL
WHITE] on all projectors.
10) Set [BRIGHTNESS CONTROL GAIN]
of all projectors to 100 %.
11) Set [BRIGHTNESS CONTROL GAIN]
of the darkest projector to 90 %.
12) Adjust [BRIGHTNESS CONTROL
GAIN] of the other projectors to that
of the projector that was set to 90 %.
13) Set [MODE] of [BRIGHTNESS
CONTROL SETUP] of all projectors to
[AUTO] and set [LINK] to [GROUP A].
14) [APPLY] [BRIGHTNESS CONTROL
SETUP] of all projectors and press
<ENTER> button.
z
Brightness control will commence.
Note
z
The brightness is corrected automatically each time the
lamps are turned on using the power switch etc.
If the brightness fluctuates significantly or the lamp has
z
been replaced, re-adjust the brightness control.

STANDBY MODE

You can select the electrical consumption while in
standby mode.
Press ▲▼ to select [STANDBY MODE].
1 )
Press ◄► to switch [STANDBY
2 )
MODE].
z
The setting will change as follows each time
◄► is pressed.
NORMAL
Note
z
With [ECO] setting, NETWORK function, RS-232C output
and some of RS-232C commands are not available.
When switch on the projector, projection will start about
10 seconds late.

SCHEDULE

This sets the command execution schedule for each
day of the week.
J
How to enable the SCHEDULE
function
Press ▲▼ to select [SCHEDULE].
1 )
Press ◄► to switch [SCHEDULE].
2 )
z
The setting will change as follows each time
◄► is pressed.
Note
z
If [SCHEDULE] is set to [ON], the setting for [STANDBY
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
J
How to assign a program
1 ) With [SCHEDULE] switched to [ON],
press <ENTER> button.
z
The [SCHEDULE] screen will be displayed.
2 ) Select and assign program to each day
of week.
Press ▲▼ to select a day of week and press
z
◄► to select a program number.
z
You can set the program from No.1 to No.7.
"- - -" indicates that the program number has
not been set yet.
J
How to set a program
You can set up to 16 commands to each program.
On the [SCHEDULE] screen, press ▲▼
1 )
ECO
to select [PROGRAM EDIT].
Press ◄► to select a program number
2 )
to be set and press <ENTER> button.
Press ▲▼ to select a command
3 )
number and press <ENTER> button.
You can change the page using ◄►.
z
PROJECTOR SETUP menu
ON OFF
81
ENGLISH -