Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual page 80

PROJECTOR SETUP menu
z
Details of error
Error message
[Exceed maximum
number of projectors.]
[Please check the
COMMAND CONTROL
setting.]
[Please check the
USER NAME and
PASSWORD in the
COMMAND CONTROL
setting.]
[Cannot apply
BRIGHTNESS
CONTROL. Please
check projector status.]
[Brightness Sensor
Error]
Note
z
If the linked projectors are not listed, check the following.
•
The devices on the network all have different IP
addresses.
•
The LAN cable is connected correctly.
•
The sub-nets of the projectors are the same.
•
The [LINKS] are set in the same group.
z
For changing the projector name, refer to
SETUP" of "NETWORK menu" (
config page" ( Æ
page 106).
80
- ENGLISH
Remedial measure
•
Limit number of
projectors in same group
to 8.
•
When linking 9 or
more projectors, use a
computer and the [Multi
Projector Monitoring &
Control Software].
•
Turn [ON] the
[COMMAND CONTROL]
on the on-screen menu
[NETWORK CONTROL]
for the projector with the
error display.
•
Set [COMMAND
PORT] of [NETWORK
CONTROL] of all linked
projectors to the same
value.
•
Set the [USER NAME]
and [PASSWORD] for the
administrator authority for
[WEB CONTROL] of all
the linked projectors to
the same text string.
•
Projector is in standby
state. Turn on power.
•
There is a fault in the
brightness sensor. If the
fault is not corrected by
turning the power off and
back on, consult your
dealer.
Æ
( page 95)
"NETWORK
■
Æ
page 94) or " Network
Q
When [MODE] of brightness control is
set to [PC]
BRIGHTNESS CONTROL STATUS
MODE PC
PROJECTOR2
RETURN
MENU
The name of this projector is displayed.
The state is indicated by color.
GREEN : The brightness can be corrected by a
significant margin.
YELLOW : The brightness can no longer be
corrected by a significant margin.
RED : There is an error in brightness control.
J
Example of adjustment procedure
for brightness control
The following is an example of adjustment procedure
for linking the brightness of 8 projectors that form a
network.
1 ) Connect all the projectors to the hub
using the LAN cables. (
2 ) Turn on the power in all projectors.
3 ) Ensure [LAMP SELECT] of all the
projectors are either all set to [DUAL]
or all set to [SINGLE].
4 ) Set [MODE] of [BRIGHTNESS
CONTROL SETUP] to [OFF], and
select [APPLY].
5 ) Set [SUBNET MASK] of all the
projectors to the same value and set
their [IP ADDRESS] to different values
so that network communication can
be performed.
6 ) Wait at least 8 minutes until the lamp
power stabilizes.
7 ) Set all the items in the [PICTURE]
menu of all the projectors to the same
value.
8 ) To match the color, adjust [COLOR
MATCHING].
Æ
page 95)